Wood Stain How To

Wipe down the wood to raise the grain.

Wood stain how to. Stir your can of stain thoroughly using a wooden or plastic stirring utensil. You can control the shading to a point by how long you leave the stain on the wood before wiping up the excess. If you don t raise the grain now the stain will raise it later but re sanding. Give the conditioner about 15 minutes to dry before applying the stain but don t sand it.

Start with wood stain sealer divide a test board into three sections. Dip your rag or brush into the stain and spread it on the wood working your way across the piece in sections. Always test stain on a piece of scrap wood before starting on the furniture. Let the wood dry then sand with 180 to 220 grit paper.

Apply it going in the same direction as the wood grain. Use a paint brush with natural fibers to apply a thick even layer of the stripper to the surface. The trick is to use the right thinner apply it in small quantities mix thoroughly and test the thinned stain until you obtain satisfactory results all while staying safe. Learn how to apply wood stain with both varathane wood stain and varathane premium fast dry wood stain.

Use a rag or brush to apply the stain to the wood. This can get a little messy but the important thing is laying down a nice generous coat. Let sit for one to five minutes. On woods with large open pores such as oak mahogany and ash increase your pressure to work the stain into the pores.

Leave one section raw wipe full strength sealer on one section and wipe half strength sealer on the third section. Remove dust with a clean cloth. As you can see anyone can learn how to thin wood stain and obtain even great looking surfaces. With a staining brush foam brush or cloth stroke both ways with the grain and against it.

Using a foam brush apply pre stain wood conditioner in the direction of the wood grain. Rubbing or brushing against the direction of the grain will help fill deep pores with stain. So that the stain doesn t leave blotches on the wood always apply a thin coat of wood conditioner first using an inexpensive brush. Apply the wood stain remover pour the stain remover into a glass or metal container and apply according to manufacturer s instructions.

Let it dry for about an hour and sand lightly with 220 grit paper. It will look like watered down glue but it will dry transparent.